How much space do you need around a bathtub?

Bathtubs. While there are no code requirements for tub size, minimum clear floor space alongside a bathtub should be at least 60 inches long (the length of a standard tub) and 30 inches wide. Always allow clear space for access to plumbing and/or whirlpool motors.

What are the rough in measurements for a bathtub drain?

Plumbing Rough-In You’ll rough in the tub drain with 1 1/2-inch pipe with male threads that extend 1/2-inch above the level of the floor. The drain will also require a P-trap and must be vented; specific requirements for the trap, drain line and vent will vary by local building codes.

How much space do you need for shower plumbing?

Code Requirements: A minimum space of 24 inches must be planned in front of a shower entry.

Do corner tubs save space?

Regardless of the size of your bathroom and its contents, corner bathtubs can easily optimize your floor space and squeeze into any corner. They are designed in such a way so as to fill up any underutilized space in your bathroom, as they do not require any long walls along the edges.

What is a left drain tub?

Right handed or left handed tub refers to the drain orientation of your tub. If the drain is to your right you have a right handed tub, and if the drain is on your left you have a left handed tub.

How do you measure a bathtub drain flange?

Measure straight down from the center of the overflow to the point at which the drain is mounted to the tub: depending on what’s easiest to get to, you can measure from outside the tub down to its underside, or from inside the tub to the tub floor. Do not follow the curve of the tub; measure straight down.

What’s the best way to plumb a bathroom?

From the center of the drain, measure 4 inches to the left and 4 inches to the right. Moving over to the toilet. The center of the closet flange is 12 inches from the finished rear wall. If you’re measuring from an unfinished wall, don’t forget to add the wall thickness to this 12 inches.

What’s the best way to install a bathtub?

They’re noted in the video already but 1) Use ABS Glue, not PVC glue, 2) Always apply the glue to both fittings – not just one and 3) make sure the opening on the overflow valve face down, not up. Thanks for the feedback, guys. We’ve been using the bathroom for about a year and everything’s working great. Loading…

How do you install a P trap in a bathtub?

The P-trap usually fits snugly in the space between the floor joists, and you connect the drain to the rest of the bathroom plumbing and the vent to the vent network. Install PEX, CPVC or copper water lines (galvanized pipes aren’t recommended), hook them up to the bathtub faucet and your new bathtub is ready to trim out.

What do you need to know about a bathtub drain?

Here are a few bathtub drain schematics and bathtub plumbing diagrams. Fairly simple drain system. If you have to hold your drain lever down for the tub to drain it is more than likely the tension spring on the back of the overflow plate. You can replace just this plate at your hardware store for a few dollars.

How big should a plumbing line be in a bathroom?

Measure 21 inches (approximately) above the finished floor. The hot line and cold line are spaced 8 inches apart (from left to right). From the center of the drain, measure 4 inches to the left and 4 inches to the right. Moving over to the toilet.